Published August 24, 2026 at 02:33
In a brewery there are two liquids that both need to hold the right concentration, and they have nothing to do with each other. One is the wort — the thing you’re making. The other is the propylene glycol in the cooling system — the thing that makes the making possible. The first is measured carefully every batch. The second is usually topped up by feel, until someone discovers one winter why that was a bad idea.
What it is
A digital handheld refractometer with three scales for brewing.
- Wort, dissolved solids: 0 to 30% DS, resolution and accuracy 0.1
- Specific gravity D20/20 °C: 1.000 to 1.127, resolution 0.001
- Propylene glycol, freezing point in °C: 0 down to minus 51, resolution 1
- Automatic temperature compensation, reading in a few seconds
The problem it solves
The glycol scale doesn’t show concentration, but freezing point — and that’s the right quantity to control by. Nobody really cares whether the mixture is 34 or 38 percent. The question you actually have is: will it withstand the lowest temperature the system will run at? By reading the answer directly, you skip the intermediate step of tables, and you skip the most common error that arises there — calculating with volume percent when the table applies to weight percent, or vice versa.
Stronger isn’t safer. It’s easy to think that extra glycol just gives extra margin, but propylene glycol is viscous and conducts heat worse than water. A mixture that’s too strong gives poorer heat transfer in the exchanger, higher pressure drop, and a pump working harder for the same output — and in the worst case, cooling capacity that isn’t enough on the hottest days. A mixture that’s too weak, on the other hand, can form ice in the exchanger, and ice expanding in a narrow channel cracks it. So there’s an optimum in the middle, and it can only be maintained if you measure.
The mixture changes on its own over time. Water gets topped up when the pressure drops, leaks get fixed with whatever happens to be on hand, and slowly the concentration drifts away from what was once set. Since nothing happens until it gets really cold, it’s a fault that stays hidden all summer and shows up in January.
The two wort scales are tied to the same idea. Dissolved solids and specific gravity are two ways of expressing the same measurement, and both are based on the relationship between refractive index and real wort sugars — not on a sucrose curve. That means the values can be used directly in the calculations and tables the brewery already works with, instead of first needing to be corrected.
Three typical use cases
- Brewing: checking the wort’s sugar content before and during fermentation, batch by batch and documented.
- Cooling system maintenance: checking the glycol’s freezing point ahead of the cold season and after refilling.
- Wort chillers and tank cooling: monitoring the condition of the coolant, where cooling capacity determines how quickly a batch can be chilled down.
Why it pays off
A cracked heat exchanger or a frozen cooling coil doesn’t just cost the repair. It costs the batch that was sitting in the tank when it happened, and the downtime in the middle of a production schedule. Against that, a check that takes ten seconds with a few drops of liquid is one of the cheapest insurance policies there is in a brewery.
The fact that the same instrument also covers the wort means checking the cooling system doesn’t require any extra purchase, or any extra occasion. It can be done by the same person, with the same tool, on the same round — and that’s in practice what determines whether it actually gets done.